After a month of off-and-on power issues with my Dell Inspiron 1525 Laptop, the A/C power adapter finally stopped powering the laptop. It had stopped being identified as an authentic Dell charger a couple months ago, as I wrote about here.
I was quite certain that the power cable had broken internally due to the constant flexing. It’s happened on almost every laptop that I’ve owned. Slightly jiggling the power cable approximately where it flexes during natural use would cut power to the laptop. Putting little stresses in the cable with twist ties would sometimes make the power work for a few days. These fixes were really temporary – they only put off the inevitable complete failure.
The options are to buy a band new authentic Dell PA-12 (or higher rated) power adapter for more than $100 directly from Dell, buy a 3rd party “compatible” charger for about $20 from eBay or DealExtreme.com (but I don’t trust 3rd party items when they plug into the household power… I don’t like fires), find a used authentic charger, or cut the cord and solder things up again.
So, the other day I cut the cable. Here are a couple pictures that might make it easier for anyone who needs to do this in the future.
Dell Laptop Cable Inside - Cable Half
This is the cable half of the cut. You can see the top of the magnetic field minimizers… the name of which escapes me right now. There are three conductors. The tiny one in the center is for the chip in the PSU that tells the laptop whether or not the charger is an authentic Dell device – in my case, this broke months ago, when the Dell battery stopped charging – even after re-soldering, this charger still does not register as authentic; there must be another break further up the cable. Then two more layers of conductors. I’ve covered off the outermost in red tape as I prepare to re-solder things together.
Dell Power Cable - Plug Half
This is the plug half of the cut. I’ve removed some sort of epoxy or hot-glue that held the above wires together in the form that fit inside the plastic shroud. I think it’s hot-glue because it seems to hold the shroud over the plug. I managed to pull the shroud off without cutting it, by running a unrolled paper clip around the edge, breaking the glue’s bond a little at a time.
As I expected, the outermost strands had all broken from repeated movement. You can see the random fraying in the strands at the top left. Also, the center wire was clearly detached. The 2nd conductor, white, on the right, was OK.
I’m not very good at soldering to plugs. I tend to melt the plastic badly before getting the metal parts hot enough to solder. So, instead of disconnecting the stubs left over in the image above and soldering directly to the plug, I decided to trim them up and splice the wires together and inch or so from the plug. The middle wire I soldered directly.
Then I used hot glue to keep things from flexing, then wrapped it all with electrical tape. The end result is passable, but not pretty, so I won’t post a picture. And my Dell lives for another day… I’m using it to type this post now!
Comments appreciated!
